Owner's manual

176 Script Commands
Set Foreign Physical Disk to Native
This command incorporates foreign physical disks that have not been
imported into the storage array configuration through normal means. This
operation is for emergency recovery use only. Use this statement only when
one or more physical disks were added after the configuration adoption
process completed.
NOTICE: Using this command for purposes other than what is stated above might
result in data corruption or data loss without notification.
Syntax
set (physicalDisk [ trayID , slotID ] |
allPhysicalDisks) nativeState
Parameters
Set Host
This command assigns a host to a host group or moves a host to a different
host group. You can also create a new host group and assign the host to the
new host group with this command. The actions performed by this command
depend on whether the host has individual virtual disk-to-LUN mappings or
does not have individual virtual disk-to-LUN mappings.
Syntax
set host [ hostName ]
hostGroup=(
"hostGroupName" | none | defaultGroup)
userLabel=
"newHostName"
hostType=( hostTypeIndexLabel |
hostTypeIndexNumber )
Parameter Description
physicalDisk The tray and the slot where the physical disk
resides. Tray ID values are 0 to 99. Slot ID values
are 0 to 31. Enclose the tray ID values and the
slot ID values in square brackets ([ ]).
allPhysicalDisks Selects all the physical disks.