Owner's manual

Script Commands 179
Set Host Port
This command changes the host type for an HBA host port. You can also
change an HBA host port label with this command.
Syntax
set hostPort [ portLabel ] host= “hostName”
userLabel=
“newPortLabel”
Parameters
NOTE: When you use this command, you can specify one or more of the optional
parameters. You do not, however, need to use all of the parameters.
NOTE: You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Set iSCSI Initiator
This command sets the attributes for an iSCSI initiator.
Syntax
set iscsiInitiator iscsiName = new-iSCSI-ID |
userLabel =
new-name | host = new-host-name |
chapSecret =
new-password
Parameter Description
hostPort The name of the HBA host port for which you want to change the
host type, or for which you want to create a new name. Enclose the
HBA host port name in square brackets ([ ]). If the HBA host port
label has special characters, enclose the HBA host port label in
double quotation marks (" ").
host The name of the host to which the HBA host port is connected.
Enclose the host name in double quotation marks (" ").
userLabel The new name that you want to give to the HBA host port. Enclose
the new name of the HBA host port in double quotation marks (" ").