Owner's manual

224 Script Commands
Syntax
start enclosure [ enclosureID ] blink
Parameter
Start iSCSI DHCP Refresh
This command initiates a refresh of the DHCP parameters for the iSCSI
interface. If the configuration method for the interface is not set to DHCP,
the procedure returns an error.
Syntax
start storageArray [ iscsi-host-port ] dhcpRefresh
Parameter
NOTE: This operation ends the iSCSI connections for the portal and brings down
the portal temporarily.
Start Physical Disk Channel Fault Isolation Diagnostics
This command runs the physical disk channel fault isolation diagnostics and
stores the results.
Syntax
start physicalDiskChannel [(1 | 2)] controller [(0
| 1)]
Parameter Description
enclosure Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
Parameter Description
iscsi-host-port The identifier of the port on the storage array on which you want to
refresh the DHCP parameters. Enclose the iSCSI host port name in
square brackets
([ ]).