Owner's manual

Script Commands 227
Start Physical Disk Reconstruction
This command starts reconstructing a physical disk.
Syntax
start physicalDisk [ enclosureID,slotID ]
reconstruct
Parameters
Start Storage Array Blink
This command identifies a storage array by turning on the indicator LED for
the storage array. (Use the stop storageArray blink command to turn off the
indicator LED for the storage array.)
Syntax
start storageArray blink
Parameters
None.
Example
-c "start storageArray blink ;"
Start Disk Group Import/Export
The import command moves a disk group into a Complete state to make a
newly introduced disk group available to its new storage array. The disk group
must be in an Exported state or a Forced state before you run this command.
Upon successfully running the command, the disk group is operational.
Parameter Description
physicalDisk Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.