Owner's manual

Contents 9
Reset Storage Array Battery Install Date . . . . . 161
Reset Storage Array iSCSI Baseline
. . . . . . . . 162
Reset Storage Array SAS PHY Baseline
. . . . . . 162
Reset Storage Array Virtual Disk Distribution
. . . 162
Revive Disk Group
. . . . . . . . . . . . . . . . . 163
Revive Physical Disk
. . . . . . . . . . . . . . . . 163
Save Enclosure Log Data
. . . . . . . . . . . . . 164
Save Physical Disk Channel Fault Isolation
Diagnostic Status
. . . . . . . . . . . . . . . . . 164
Syntax
. . . . . . . . . . . . . . . . . . . . . . . 164
Save Physical Disk Log
. . . . . . . . . . . . . . . 165
Save RAID Controller Module NVSRAM
. . . . . . 165
Save Storage Array Configuration
. . . . . . . . . 166
Save Storage Array Events
. . . . . . . . . . . . 167
Save Storage Array iSCSI Statistics
. . . . . . . . 168
Save Storage Array Performance Statistics
. . . . 169
Save Storage Array SAS PHY Counts
. . . . . . . 169
Save Storage Array State Capture
. . . . . . . . . 170
Save Storage Array Support Data
. . . . . . . . . 170
Set Controller
. . . . . . . . . . . . . . . . . . . . 170
Additional Information
. . . . . . . . . . . . . . . 172
Set Disk Group
. . . . . . . . . . . . . . . . . . . 173
Set Enclosure Attribute
. . . . . . . . . . . . . . 174
Set Enclosure Identification
. . . . . . . . . . . . 175
Set Foreign Physical Disk to Native
. . . . . . . . 176
Set Host
. . . . . . . . . . . . . . . . . . . . . . 176
Set Host Group
. . . . . . . . . . . . . . . . . . . 178
Set Host Port
. . . . . . . . . . . . . . . . . . . . 179
Set iSCSI Initiator
. . . . . . . . . . . . . . . . . 179
Set iSCSI Target Properties
. . . . . . . . . . . . 180
Set Physical Disk Channel Status
. . . . . . . . . 182
Set Physical Disk Hot Spare
. . . . . . . . . . . . 182
Set Physical Disk State
. . . . . . . . . . . . . . . 183