Users Guide

You cannot rename or remove existing configured hosts or host groups. Existing host and host

group configuration changes must be performed from the MD storage management software. Click

Next after all host groups and hosts have been defined.

7. The Review Changes page is then displayed showing the changes that are applied to the storage

array. If you accept the changes, click the Next button.

8. A real-time summary page is then displayed showing the status of the changes being applied to the

selected storage array. After the changes have been applied, click the Re run button to repeat the

configuration process on another storage array or click Close to close the configuration wizard. You

must manually close the progress window after the changes are complete.

NOTE: To use multiple host groups as described, the storage array must have the Storage

Partitioning premium feature enabled.

NOTE: By default, the wizard displays only hosts that are prefixed with ‘ESX_’ and host groups

prefixed with ‘VMware_’. Other hosts or host groups configured on the storage array are not

displayed in the wizard unless the Show all host groups check box is selected.

Figure 19. Apply changes message box