Users Guide

Figure 49. Change virtual disk Copy Parameters
3. From the Copy Priority drop-down menu, select the new priority for the virtual disk copy.
4. Clear the Target virtual disk Read-Only check box to allow for read-write of the target virtual disk
copy.
5. Click OK.
Remove Copy Pair
The Remove Copy Pair command removes the relationship of the source and target of a virtual disk copy
pair. This command does not remove the target virtual disk or the data residing on the target virtual disk.
To remove a virtual disk copy pair relationship, perform the following task:
1. Select the virtual disk copy pair to be removed.
2. Click Remove Copy Pair icon from the Actions drop-down menu.
3. Click OK to remove the virtual disk copy pair or Cancel.
Figure 50. Remove Copy Pair
Snapshots view features
MD storage arrays with controller firmware 7.84 and later support Point-in-Time (PiT) based snapshots.
These snapshots provide a PiT image of the base virtual disk that may be used to revert to, or presented
to an alternate host as read-only or read-write virtual disk. The following commands are available from
this view:
• Create Snapshot Group
• Create Snapshot Image
• Create Snapshot Virtual Disk
59