Users Guide

• Change Replication Settings

• Change Replicated Roles

• Test Replication Communication

• Remove Replicated Pairs

Figure 62. Remote Replication (Legacy) view

Create Remote Replication (legacy)

The Remote Replication (Legacy) command is used to establish a remote replication (legacy) between

two storage arrays connected using fibre channel. To establish a new remote replication, perform the

following task:

NOTE: To create a remote replication (legacy), both the local and the remote storage arrays must

be added to the Array Manager view.

1. Select the Create Remote Replication (Legacy) command.

2. Review the Introduction wizard instructions, and then click Next.

3. Select the primary virtual disk for the replication relationship, and then click Next.

4. From the drop-down menu, select the remote storage array for the replication.

5. From the drop-down menu, select the secondary virtual disk to be the target of the primary virtual

disk.

6. Select the write mode for the remote replication, and then click Next.

7. Select resynchronization method to use.

8. From the drop-down menu, select the synchronization priority for the replication, and then click

Next.

9. Review the Confirmation page, and then click Finish to establish the replicated relationship.