Users Guide

1. Select Test Replicated Communication from the Actions drop-down menu.

2. Click OK to close the dialog box after reviewing the information display.

Figure 65. Test Replicated Communication results

Remove Replicated Pairs

Removing a replicated pair breaks the replication association between the virtual disk at the primary site

and the virtual disk at the secondary site. After the operation completes, the replication status between

the virtual disks is lost. For replication to be re-established between the virtual disks, a full

resynchronization must occur. To remove a replicated pair relationship, perform the following task:

1. Select an existing replicated pair in the Replicated Pairs window.

2. Select Remove Replicated Pairs command from the Actions drop-down menu.

3. Click OK to remove the replicated pair or Cancel to cancel the process in the Remove Replicated

Pairs

dialog box.

NOTE: The remove action will not remove the secondary virtual disk from the remote array or

remove the existing data on the secondary virtual disk.