Owner manual

Notes
• The Remote Replication premium feature must be enabled and activated on the local and remote storage arrays
that will be used for replication activities.
• You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Names can
have a maximum of 30 characters.
• The local and remote storage arrays must be connected through a Fibre Channel fabric or iSCSI interface.
• Passwords are stored on each storage array in a management domain. If a password was not previously set,
you do not need a password. The password can be any combination of a alphanumeric characters with a
maximum of 30 characters. (You can define a storage array password by using the set storageArray
command.)
• Depending on your configuration, there is a maximum number of remote replication groups you can create on a
storage array.
• Remote replication groups are created empty and replicated pairs are added to them later on. Only replicated
pairs can be added to a remote replication group. Each replicated pair is associated with exactly one remote
replication group.
• The Remote Replication process is initiated at a defined synchronization interval. Periodic point-in-time images
are replicated as only the changed data is copied and not the entire virtual disk.
Create Snapshot Group
Description
This command creates a new snapshot group and the associated repository virtual disk. A snapshot group contains a
sequence of snapshot images of an associated base virtual disk. A snapshot group has a repository virtual disk that is
used to save data for all of the snapshot images that are part of the snapshot group.
Syntax
create snapGroup userLabel="snapGroupName" sourceVirtualDisk="virtualDiskName"
repositoryVirtualDisk="repos_xxxx"
[repositoryFullPolicy=(failBaseWrites | purgeSnapImages) |
rollbackPriority=(high | highest | medium | low | lowest) |
repositoryFullLimit=
percentValue |
autoDeleteLimit=numberOfSnapImages]
Parameters
Parameter Description
userLabel
The alphanumeric identifier (including - and _) that you
want to give the new snapshot group. Enclose the
snapshot group identifier in double quotation marks (" ").
sourceVirtualDisk
The alphanumeric identifier (including - and _) of the
virtual disk that you want to use as the source for your
snapshot images. Enclose the source virtual disk name in
double quotation marks (" ").
179