Owner manual

Download Storage Array NVSRAM
Description
This command downloads NVSRAM values for the storage array RAID controller module.
Syntax
download storageArray NVSRAM file="filename"
Parameter
Parameter Description
file
File path and name of the file that contains the NVSRAM
values. Valid file names must end with a .dlp extension.
You must put quotation marks (" ") around the file name.
Enable Disk Group Security
Description
This command converts a non-secure disk group to a secure disk group.
Syntax
enable diskGroup [diskGroupName] security
Parameter
Parameter Description
diskGroup
The alphanumeric identifier (including - and _) of the disk
group that you want to place in the Security Enabled state.
Enclose the disk group identifier in square brackets ([ ]).
Additional Information
To successfully run this command, the following conditions must be met:
• All physical disks in the disk group must be self-encrypting disk (SED) physical disks.
• The Physical Disk Security premium feature must be enabled.
• The storage array security key must be set.
• The disk group must be Optimal, and not have snapshot virtual disks or repository virtual disks.
The RAID controller module firmware creates a lock that restricts access to the SED physical disks. SED physical disks
have a state called Security Capable. When you create a security key, the state is set to Security Enabled, which
restricts access to all SED physical disks that exist within the storage array.
215