Owner manual

Syntax
remove remoteReplication (localVirtualDisk [virtualDiskName] |
localVirtualDisks [
virtualDiskName1... virtualDiskNameN])
Parameter
Parameter Description
localVirtualDisk or localVirtualDisks
The name of the primary virtual disk (the virtual disk on the
local storage array) that you want to remove. You can
enter more than one virtual disk name. Enclose the virtual
disk name in square brackets ([ ]). If the virtual disk name
has special characters, you also must enclose the virtual
disk name in double quotation marks (" ").
Remove Virtual Disk Copy
Description
This command removes a virtual disk copy pair.
Syntax
remove virtualDiskCopy target [targetName]
[source [sourceName]]
copyType=(online | offline)
Parameters
Parameter Description
target
Name of the target virtual disk to remove. You must put
brackets ([ ]) around the target virtual disk name. If the
target virtual disk name has special characters, you must
also put quotation marks (" ") around the target virtual disk
name.
source
Name of the source virtual disk to remove. You must put
brackets ([ ]) around the source virtual disk name. If the
source virtual disk name has special characters, you must
also put quotation marks (" ") around the source virtual
disk name.
copyType
Identifies a virtual disk copy with a snapshot. If the virtual
disk copy has an online copy snapshot, set this parameter
to online. If the virtual disk copy does not have a
snapshot, set this parameter to offline.
231