Owner manual

Parameter Description
name must also be enclosed in double quotation marks
(“ ”).
writeConsistency
The setting to identify the virtual disks in this command
that are in a write-consistency group or are separate. For
the virtual disks to be in the same write-consistency
group, set this parameter to TRUE. For the virtual disks to
be separate, set this parameter to FALSE.
NOTE: If you set the writeConsistency parameter to TRUE, the virtual disks must be in a write-consistency
group (or groups). This command resumes all write-consistency groups that contain the virtual disks. For example,
if virtual disks A, B, and C are in a write-consistency group and they have remote counterparts A’, B’, and C’, the
resume remoteReplication virtual disk [“A”] writeConsistency=TRUE command
resumes A-A’, B-B’, and C-C’.
Resume Remote Replication Group
Description
This command resumes data transfer between all replicated pairs in a remote replication group. Data written to the
primary virtual disks while the remote replication group was suspended is written to the secondary virtual disks
immediately. Periodic synchronization resumes if an automatic synchronization interval has been set.
Syntax
resume asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
Parameter
Parameter Description
asyncRemoteReplicationGroup
The name of the remote replication group that you want to
resume. Enclose the remote replication group name in
square brackets ([ ]). If the remote replication group name
has special characters, you also must enclose the remote
replication group name in double quotation marks (" ")
inside square brackets. If the remote replication group
name consists only of numbers, such as "1002," you also
must enclose the remote replication group name in double
quotation marks (" ") inside square brackets.
Resume Snapshot Image Rollback
Description
This command resumes a rollback operation that has entered a paused state. A rollback operation can enter a paused
state due to processing errors, which causes a Needs Attention condition for the storage array.
243