Owner manual

Revive Snapshot Virtual Disk
Description
This command forces a specified snapshot virtual disk to the Optimal state. The snapshot virtual disk can be:
• A standalone snapshot virtual disk
• A snapshot virtual disk that is a member of a consistency group
If the snapshot virtual disk is not in a Failed state, the firmware displays an error message and does not run this
command.
NOTE: You cannot use this command for a snapshot virtual disk that is used in online virtual disk copy.
Syntax
revive snapVirtualDisk [snapVirtualDiskName]
Parameter
Parameter Description
snapVirtualDisk
The alphanumeric identifier (including - and _) of the
snapshot virtual disk that you want to set to the Optimal
state. Enclose the snapshot virtual disk identifier in square
brackets ([ ]).
Save Enclosure Log Data
Description
This command saves the enclosure log sense data to a file. Log sense data is maintained by the environmental cards for
each enclosure. Not all of the environmental cards contain log sense data.
Syntax
save allEnclosures logFile="filename"
Parameter
Parameter Description
logFile
Name of the file to which to save the log sense data. You
must put quotation marks (" ") around the file name.
249