Owner manual

Parameter
Parameter Description
logFile
Name of the file to which to write the log sense data. You
must put quotation marks (" ") around the file name.
Save RAID Controller Module NVSRAM
Description
This command saves a copy of the RAID controller module NVSRAM values to a file. This command saves all regions.
Syntax
save controller [(0 | 1)] NVSRAM file="filename"
Parameters
Parameter Description
controller
RAID controller module with the NVSRAM values to save.
Valid RAID controller module identifier values are 0 and 1.
The identifier value is 0 for the RAID controller module on
the top and
1 for the RAID controller module on the
bottom when viewed from the rear of the enclosure. You
must put brackets ([ ]) around the RAID controller module
identifier.
file
Name of the file in which to save the values. You must put
quotation marks (" ") around the file name.
Save Remote Replication Group Statistics
Description
This command saves to a file the synchronization statistics for one or more member virtual disks in a remote replication
group. The statistics collected are available only for remote replication group member virtual disks in a primary role on
the local storage array.
A set of data is collected during the synchronization process that can be used to evaluate how well the replication
configuration is functioning. The data is collected as a set of samples. A sample is created at the beginning of a
synchronization process and updated regularly while the synchronization process proceeds.
A sample collects data until the synchronization process completes or until a disruption to the synchronization process
occurs such as a virtual disk ownership transfer or a read-write error. When a synchronization process disruption is
resolved (for example, the virtual disk is transferred to the alternate RAID controller module), a new sample is created
and updated as the synchronization process continues.
251