Owner manual

Syntax
set hostGroup [hostGroupName]
userLabel="
newHostGroupName"
Parameters
Parameter Description
hostGroup
Name of the host group to rename. You must put brackets
([ ]) around the host group name. If the host group name
has special characters, you must also put quotation marks
(" ") around the host group name.
userLabel
New name for the host group. You must put quotation
marks (" ") around the host group name.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Port
Description
This command changes the host type for an HBA host port. You can also change an HBA host port label with this
command.
Syntax
set hostPort [portLabel] host=“hostName”
userLabel=“newPortLabel”
Parameters
Parameter Description
hostPort
The name of the HBA host port for which you want to
change the host type, or for which you want to create a
new name. Enclose the HBA host port name in square
brackets ([ ]). If the HBA host port label has special
characters, enclose the HBA host port label in double
quotation marks (" ").
host
The name of the host to which the HBA host port is
connected. Enclose the host name in double quotation
marks (" ").
273