Owner manual

Command Syntax Description
recover object { statement‑data } Re-creates an object from saved configuration data and
the statement attributes (similar to the create command).
recreate object { statement‑data } Restarts a snapshot operation using an existing snapshot
virtual disk. You can change attributes before the
operation is restarted.
remove object { statement‑data } Removes a relationship from between objects.
repair object { statement‑data } Repairs errors found by the check command.
reset object { statement‑data } Returns the hardware or object to an initial state.
resume object Starts a suspended operation. The operation begins
where it left off when suspended.
revive object Forces the object from the Failed to the Optimal state. Use
only as part of an error recovery procedure.
save object { statement‑data } Writes information about the object to a file.
set object { statement‑data } Changes object attributes. All changes are completed
when the command returns.
show object { statement‑data } Displays information about the object.
start object { statement‑data } Starts an asynchronous operation. You can stop some
operations after they have started. You can query the
progress of some operations.
stop object { statement‑data } Stops an asynchronous operation.
suspend object { statement‑data } Suspends an operation. You can then restart the
suspended operation, and it continues from the point at
which it was suspended.
Recurring Syntax Elements
Recurring syntax elements are a general category of variables and parameters you can use in one or more script
commands. The recurring syntax is used in the general definitions of the script commands that are listed in Script
Commands. The following table lists the recurring syntax and the syntax values that you can use with the syntax.
Table 7. Recurring Syntax Elements
Recurring Syntax Syntax Value
raid-level (0 | 1 | 5| 6)
snapshot-repository-raid-level (1 | 5 | 6)
capacity-spec integer-literal [KB | MB | GB | TB | Bytes]
segment-size-spec integer-literal
boolean (TRUE | FALSE)
user-label string-literal
user-label-list user-label { user-label }
30