Owner manual

Set Storage Array Unnamed Discovery Session
Description
This command enables the storage array to participate in unnamed discovery sessions.
Syntax
set storageArray unnamedDiscoverySession=(TRUE | FALSE)
Parameter
Parameter Description
unnamedDiscoverySession
This parameter turns on or turns off unnamed discovery
sessions. Set the parameter to TRUE to turn on unnamed
discovery sessions. Set the parameter to FALSE to turn
off unnamed discovery sessions.
NOTE: Discovery is the process where initiators determine the targets that are available. Discovery occurs at
power-on/initialization and also if the bus topology changes, for example, if an extra device is added.
NOTE: An unnamed discovery session is a discovery session that is established without specifying a target ID in
the login request. For unnamed discovery sessions, neither the target ID nor the target portal group ID are
available to the targets.
Set Thin Virtual Disk Attributes
Description
This command defines the properties for a thin virtual disk. You can use the parameters to define properties for one or
more thin virtual disks.
Syntax
set (virtualDisk ["virtualDiskName"] |
virtualDisks ["virtualDiskName1" ... "virtualDiskNameN"] | virtualDisk <wwID>)
[newCapacity=capacityValue | repositoryMaxCapacity=capacityValue|
repositoryExpansionPolicy=(automatic|manual)|
warningThresholdPercent=integer-literal | addRepositoryCapacity=capacity-spec]
Parameters
Parameter
Description
virtualDisk or virtualDisks The name of the specific virtual disk for which you want to
define properties. (You can enter more than one virtual
disk name if you use the virtualDisks parameter.)
303