Owner manual

NOTE: Use the save physicalDiskChannel faultDiagnostics command and the stop

physicalDiskChannel faultDiagnostics command in association with the start

physicalDiskChannel faultDiagnostics

command. These commands are needed to save the

diagnostic test results to a file and to stop the diagnostic test.

NOTE: You can stop this command at any time by pressing <Ctrl><C>.

Start Physical Disk Initialize

Description

This command starts physical disk initialization.

CAUTION: As soon as you enter this command, all user data is erased.

Syntax

start physicalDisk [enclosureID,slotID] initialize

Parameters

Parameter Description

physicalDisk

Identifies the enclosure and slot where the physical disk

resides. Enclosure ID values are 0 to 99. Slot ID values

are 0 to 31. You must put brackets ([ ]) around the

enclosure ID value and slot ID value.

Start Physical Disk Reconstruction