Owner manual

Parameters
Parameter Description
virtualDisk or
virtualDisks
Names the specific snapshot virtual disk or snapshot
virtual disks for which you want to start a rollback
operation. Enclose the snapshot virtual disk name in
square brackets ([ ]). If the snapshot virtual disk name has
special characters, you must also enclose the snapshot
virtual disk name in double quotation marks (" ").
Start Snapshot Image Rollback
Description
This command starts a rollback operation for a set of snapshot images. The content of the base virtual disk changes
immediately to match the point-in-time content of the selected snapshot image virtual disk. The base virtual disk
immediately becomes available for read/write requests after the rollback operation has successfully completed. To stop
a snapshot image rollback operation, use the stop rollback snapImage command.
The repository virtual disk that is associated with the snapshot image continues to track any new changes between the
base virtual disk and the snapshot image virtual disk that occur after the rollback operation is completed.
NOTE: You cannot use this command for snapshot images involved in online virtual disk copy.
Syntax
start snapImage ["snapImageName"] rollback
Parameter
Parameter Description
snapImage
The name of the snapshot image. The name of a snapshot
image is comprised of two parts:
• The name of the snapshot group.
• An identifier for the snapshot image in the
snapshot group.
The identifier for the snapshot image can be one of these:
• An integer value that is the sequence number of
the snapshot in the snapshot group.
• NEWEST - Use this option when you want to show
the latest snapshot image created in the snapshot
group.
• OLDEST - Use this option when you want to show
the earliest snapshot image created in the
snapshot group.
357