Owner manual

After completion of the virtual disk copy of a snapshot (legacy), the legacy snapshot is disabled. After completion of the
virtual disk copy using a snapshot image, the snapshot image is deleted and the snapshot virtual disk is disabled.
NOTE: You can have a maximum of eight virtual disk copies in progress at one time. If you try to create more than
eight virtual disk copies at one time, the RAID controller modules return a status of Pending until one of the virtual
disk copies that is in progress finishes and returns a status of Complete.
NOTE: Snapshots created using older (legacy) premium feature versions cannot be managed using newer
snapshot premium feature options. Also, a virtual disk in a snapshot group cannot be a target for a virtual disk
copy. If you want to choose the base virtual disk of an older (legacy) snapshot virtual disk as your target virtual
disk, you must first disable all snapshot (legacy) virtual disks that are associated with the base virtual disk.
The following table lists the Virtual Disk Copy commands.
NOTE: These commands apply when you are using a snapshot or a snapshot (legacy) image.
Table 12. Virtual Disk Copy Commands
Command Description
create virtualDiskCopy
Creates a virtual disk copy and starts the virtual disk copy
operation.
recopy virtualDiskCopy
Reinitiates a virtual disk copy operation using an existing
virtual disk copy pair.
enable storageArray feature
Activates the Virtual Disk Copy feature.
recopy virtualDiskCopy
Re-initiates a virtual disk copy operation by using an
existing virtual disk copy pair.
remove virtualDiskCopy
Removes a virtual disk copy pair.
set virtualDiskCopy
Defines the properties for a virtual disk copy pair.
show virtualDiskCopy
Returns information about virtual disk copy operations.
You can retrieve information about a specific virtual disk
copy pair, or all virtual disk copy pairs in the storage array.
show virtualDiskCopy sourceCandidates
Returns information about the candidate virtual disks that
you can use as the source for a virtual disk copy
operation.
show virtualDiskCopy targetCandidates
Returns information about the candidate virtual disks that
you can use as the target for a virtual disk copy operation.
stop virtualDiskCopy
Stops a virtual disk copy operation.
Creating A Virtual Disk Copy
Before creating a virtual disk copy, ensure that a suitable target virtual disk exists on the storage array, or create a new
target virtual disk specifically for the virtual disk copy. The target virtual disk must have a capacity equal to or greater
than the source virtual disk.
You can have a maximum of eight virtual disk copies in progress at one time. Any virtual disk copy greater than eight has
a status of Pending until one of the virtual disk copies with a status of In Progress completes.
The following steps show the general process for creating a virtual disk copy:
76