CLI Guide

Parameter Description
secure drives to use. The values you can use are
fips and sed.
NOTE: The controller firmware does not
support a mix of SED and FIPS drives within
disk groups or disk pools.
Example command
autoConfigure storageArray
securityType=capable
securePhysicalDisks=fips;
dataAssurance
The setting to specify that a disk group, and the
virtual disks within the disk group, has data
assurance protection to make sure that the data
maintains its integrity. When you use this
parameter, only protected physical disks can be
used for the disk group. These settings are valid:
• none - No explicit data assurance is defined.
The disk group will be comprised of virtual disks
that may or may not have data assurance,
depending on the availability of data assurance
enabled physical disks. Data Assurance is
enabled on virtual disks created on disk groups
that support data assurance. If only data
assurance physical disks are available, the disk
groups will be data assurance enabled.
• enabled - The disk group has data assurance
protection. The disk group supports protected
information and is formatted with protection
information enabled.
NOTE: This option is only valid for
enablement, if the drives support DA.
Set FIPS drive security identifier
Description
This command is used to reset a FIPS drive back to the original manufacturer settings. This command
may be necessary if the drive is locked because of an invalid or missing security key file or unknown pass
phrase. All existing drive data will be erased.
WARNING: This command resets a FIPS drive back to the original manufacturer settings and
erases all existing drive data. This operation is irreversible.
To erase an SED drive, use the start secureErase command.
Syntax
setPhysicalDiskDrive[trayID,drawerID,slotID] securityID="string";
144