CLI Guide

[criticalThreshold=(criticalThresholdValue|default)]
[criticalPriority=(highest|high|medium|low|lowest)]
[backgroundPriority=(highest|high|medium|low|lowest)]
[degradedPriority=(highest|high|medium|low|lowest)]
[securityType=(none|capable|enabled)]
[physicalDiskMediaType=(hdd | ssd | allMedia | unknown)]
[securePhysicalDisks=(fips | sed )]
[dataAssurance=(none|enabled)]
Parameter Description
physicalDisks
The physical disks that you want to assign to the
disk pool that you want to create. For dense
physical disk enclosures, specify the enclosure ID
value, the drawer ID value, and the slot ID value for
each drive that you assign to the disk pool. For
non-dense physical disk enclosures, specify the
enclosure ID value and the slot ID value for each
physical disk that you assign to the disk pool.
Enclosure ID values are 0 to 99 . Drawer ID values
are 0 to 4 . Slot ID values are 0 to 59 . Enclose the
enclosure ID values, the drawer ID values, and the
slot ID values in parentheses.
userLabel
The name that you want to give the new disk pool.
Enclose the disk pool name in double quotation
marks (" ").
driveCount
The driveCount parameter limits the disk pool
candidates to the given number. When using this
parameter, the minimum value that you can enter
is 11. Use this parameter only when the
driveType parameter is specified.
trayLossProtect
The setting to enforce enclosure loss protection
when you create the disk pool. To enforce
enclosure loss protection, set this parameter to
TRUE. The default value is FALSE.
drawerLossProtect
The setting to enforce drawer loss protection
when you create the disk pool. To enforce drawer
loss protection, set this parameter to TRUE. The
default value is FALSE.
warningThreshold
The percentage of storage capacity at which you
receive a warning alert that the disk pool is nearing
full capacity. Use integer values. For example, a
value of 60 means 60 percent. For best operation,
the value for this parameter must be less than the
value for the criticalThreshold parameter.
Valid values are from 0 to 100.
The default value is 50.
Setting this parameter to 0 disables warning alerts.
169