CLI Guide

Parameters
Parameter Description
physicalDisk or physicalDisks
The enclosure and the slot where the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID
values are 0 to 31. Enclose the enclosure ID values
and the slot ID values in square brackets ([ ]).
allPhysicalDisks
Selects all the physical disks.
Set Host
Description
This command assigns a host to a host group or moves a host to a different host group. You can also
create a new host group and assign the host to the new host group with this command. The actions
performed by this command depend on whether the host has individual mappings or does not have
individual mappings.
Syntax
set host [hostName]
hostGroup=("
hostGroupName" | none | defaultGroup)
userLabel="newHostName"
hostType=(hostTypeIndexLabel | hostTypeIndexNumber)
Parameters
Parameter Description
host
The name of the host that you want to assign to a
host group. Enclose the host name in square
brackets ([ ]). If the host name has special
characters, you must also enclose the host name
in double quotation marks (" ").
hostGroup
The host group to which you want to assign the
host. (The following table defines how the
command runs if the host does or does not have
individual virtual disk-to-LUN mappings.) Enclose
the host group name in double quotation marks ("
"). The defaultGroup is the host group that
contains the host to which the virtual disk is
mapped.
userLabel
The new host name. Enclose the host name in
double quotation marks (" ").
hostType
The index label or number of the host type for the
HBA host port. Use the show storageArray
hostTypeTable command to generate a list of
300