CLI Guide

Parameter Description
For example, the identifier number for host
channel 2 on RAID controller module 0 would be
[0,2].
preferredID
The port identifier for the specified host port. Port
ID values are 0 to 127.
Set Host Group
Description
This command renames a host group.
Syntax
set hostGroup [hostGroupName]
userLabel="newHostGroupName"
Parameters
Parameter Description
hostGroup
Name of the host group to rename. You must put
brackets ([ ]) around the host group name. If the
host group name has special characters, you must
also put quotation marks (" ") around the host
group name.
userLabel
New name for the host group. You must put
quotation marks (" ") around the host group name.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Port
Description
This command changes the host type for an HBA host port. You can also change an HBA host port label
with this command.
Syntax
set hostPort [portLabel] host=“hostName”
userLabel=“newPortLabel”
302