CLI Guide

Parameter Description
repositoryFullLimit
The percentage of repository virtual disk capacity
at which you receive a warning that the snapshot
image repository virtual disk is nearing full. Use
integer values. For example, a value of 70 means
70 percent. The default value is 75.
Notes
The repository virtual disk name is automatically created by the MD storage management software and
the firmware when you create a new snapshot group. You cannot rename the repository virtual disk
because renaming the repository virtual disk will break the linkage with the snapshot images.
Set Remote Replication
Description
NOTE: This command is valid only with Fibre Channel storage arrays.
This command defines the properties for a remote replication pair.
NOTE: Starting with firmware 8.10, some RAID controller modules no longer support the
writeOrder parameter and the writeMode parameter.
Syntax
set remoteReplication (localVirtualDisk [virtualDiskName] |
localVirtualDisks [virtualDiskName1 ... virtualDiskNameN])
[role=(primary | secondary)]
[syncPriority=(highest | high | medium | low | lowest)]
[autoResync=(enabled | disabled)]
[writeOrder=(preserved | notPreserved)]
[writeMode=(synchronous | asynchronous)] [force=(TRUE | FALSE)]
Parameters
Parameter Description
localVirtualDisk The name local virtual disk for which you want to
define properties. Enclose the primary virtual disk
name in square brackets ([ ]). If the primary virtual
disk name has special characters or numbers, you
must enclose the primary virtual disk name in
double quotation marks (" ") inside square brackets.
localVirtualDisks The names of several local virtual disks for which
you want to define properties. Enter the names
virtual disks using these rules:
• Enclose all names in square brackets ([ ]).
• Separate each names with a space.
312