CLI Guide

Parameter Description
If the virtual disk names have special characters or
consist only of numbers, enter the names using
these rules:
• Enclose all names in square brackets ([ ]).
• Enclose each names in double quotation marks
(" ").
• Separate each names with a space.
role The setting for the local virtual disk to act as the
primary virtual disk or the secondary virtual disk. To
define the virtual disk as the primary virtual disk, set
this parameter to primary. To define the virtual
disk as the secondary virtual disk, set this
parameter to secondary. This parameter applies
only when the virtual disk is part of a replication
relationship.
syncPriority The priority that full synchronization has relative to
host I/O activity. Valid values are highest, high,
medium, low, or lowest.
autoResync The settings for automatic resynchronization
between the primary virtual disks and the
secondary virtual disks of a remote-replicated pair.
This parameter has these values:
• enabled – Automatic resynchronization is
turned on. You do not need to do anything
further to
resynchronize the primary virtual
disk and the secondary virtual disk.
• disabled – Automatic resynchronization
is turned off. To resynchronize the primary
virtual disks and the secondary virtual disk, you
must run the resume remoteReplication
command.
writeOrder This parameter defines write order for data
transmission between the primary virtual disk and
the secondary virtual disk. Valid values are
preserved or notPreserved.
writeMode This parameter defines how the primary virtual disk
writes to the secondary virtual disk. Valid values are
synchronous or asynchronous.
force The role reversal is forced if the communications
link between the storage arrays is down and
promotion or demotion on the local side results in
a dual-primary condition or a dual-secondary
condition. To force a role reversal, set this
parameter to TRUE. The default value is FALSE.
NOTE: Use the force parameter only when
using the role parameter.
313