CLI Guide

Set Snapshot Virtual Disk Repository Virtual Disk Capacity
Description
This command defines the capacity the you can set for a snapshot virtual disk repository virtual disk.
Syntax
set snapVirtualDisk ["snapVirtualDiskName"]
(repositoryFullLimit=percentValue |
increaseRepositoryCapacity (repositoryVirtualDisk=(repos_xxxx) |
decreaseRepositoryCapacity count=numberOfVirtualDisks)
Parameters
Parameters Description
snapVirtualDisk
The alphanumeric identifier (including - and _) of
the snapshot virtual disk for which you are setting
properties. Enclose the snapshot virtual disk
identifier in double quotation marks (" ") inside of
square brackets ([ ]).
repositoryFullLimit
The percentage of repository virtual disk capacity
at which you receive a warning that the snapshot
repository virtual disk is nearing full. Use integer
values. For example, a value of 70 means 70
percent. The default value is 75.
repositoryVirtualDisk
The alphanumeric identifier of the repository virtual
disk has the snapshot image. All repository
identifiers have this form: repos_xxxx where
xxxx represents a four digit numerical value.
Enclose the snapshot virtual disk name in double
quotation marks (" ").
count
The number of repository virtual disks that you
want to remove from the snapshot group. Use
integer values.
Notes
When you use this command, you can specify only one of the parameters. You cannot enter more than
one parameter when you run this command.
Set Storage Array
NOTE: With firmware version 8.10 the cacheFlushStop parameter is deprecated and will be removed
in a future release of MD storage management software.
327