CLI Guide

Description
The means of registering the iSCSI target on the iSNS server. Set the parameter to TRUE to list an iSCSI
target. When you set this parameter to TRUE you must also use these parameters for IPV4 configurations:
• isnsIPV4ConfigurationMethod
• isnsIPV4Address
When you set this parameter to TRUE you must also use these parameters for IPV6 configurations:
• isnsIPV6Address
Optionally, you can also use the isnsListeningPort parameter to define the port monitor and manage
traffic to the server. To remove the registration for the storage array from the iSNS server set this
parameter to FALSE
Syntax
set storageArray (cacheBlockSize=cacheBlockSizeValue |
cacheFlushStart=cacheFlushStartSize |
defaultHostType=("hostTypeName" | "hostTypeIdentifier")
failoverAlertDelay=
delayValue |
mediaScanRate=(disabled | 1-30) |
userRole=(admin | monitor)
password="password" |
userLabel="storageArrayName"
isnsRegistration=(TRUE | FALSE))
Parameters
Parameter Description
cacheBlockSize
The cache block size that is used by the RAID
controller module for managing the cache. Valid
values are 4 (4 KB), 8 (8 KB), 16 (16 KB), or 32 (32
KB).
cacheFlushStart
The percentage of unwritten data in the cache that
causes a cache flush. Use integer values from 0 to
100 to define the percentage. The default value is
80.
defaultHostType
The default host type of any unconfigured host
port to which the RAID controller modules are
connected. To generate a list of valid host types for
the storage array, run the show storageArray
hostTypeTable command. Host types are
identified by a name or a numerical index. Enclose
the host type name in double quotation marks (" ").
Do not enclose the host type numerical identifier
in double quotation marks.
328