CLI Guide

Parameter Description
up to seven days after the next scheduled learn
cycle.
day
Valid values for the day parameter include the days
of the week. Setting the day causes the next learn
cycle to be scheduled on the specified day, after
the currently scheduled learn cycle.
time
The time in 24-hour format; for example 8:00 a.m.
is entered as 08:00. Nine o’clock p.m. is entered as
21:00, and 9:30 p.m. is entered as 21:30.
NOTE: You can set the learn cycle to occur only once during a seven-day period. The time
parameter selects a specific time that you want to run the learn cycle. If a value is not entered, the
command uses a default value of 00:00 (midnight). If the day and time specified are in the past, the
next learn cycle takes place on the next possible day specified.
Set Storage Array Consistency Mode
Description
This command sets the consistency mode of the storage array to either simplex or duplex.
Syntax
set storageArray redundancyMode=(simplex | duplex)
Parameter
Parameter Description
redundancyMode
Use simplex mode when you have a single RAID
controller module. Use duplex mode when you
have two RAID controller modules
Set Storage Array Security Key
Description
Use this command to set the security key that is used throughout the storage array to implement the
Physical Disk Security premium feature. When any security-capable physical disk in the storage array is
assigned to a secured disk group, that physical disk is security-enabled using the security key. Before you
can set the security key, you must use the create storageArray securityKey command to create
the security key.
Syntax
set storageArray securityKey
334