CLI Guide

Parameter Description
values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID
values and the slot ID values. Use with the
addCapacity parameter if you must specify
additional physical disks to accommodate the new
size.
consistencyCheckEnabled
Turns consistency checking during a media scan
on or off. To turn consistency checking on, set to
TRUE. To turn consistency checking off, set to
FALSE.
segmentSize
Amount of data (in kilobytes) that the RAID
controller module writes on a single physical disk
in a virtual disk before writing data on the next
physical disk. Valid values are 8, 16, 32, 64, 128,
256, or 512. For information about the
segmentSize parameter, see Using The Auto
Configure Command.
userLabel
Specifies the new name to give an existing virtual
disk. You must put quotation marks (" ") around the
new virtual disk name.
preReadRedundancyCheck
The setting to check the consistency of RAID
redundancy data on the stripes during read
operations. Do not use this operation for
nonredundant virtual disks, for example RAID Level
0. To check redundancy consistency, set this
parameter to TRUE. For no stripe checking, set this
parameter to FALSE.
accessVirtualDisk
Specifies the logical unit number for the access
virtual disk. The logical unit number is the only
property that you can set for the access virtual
disk.
NOTE: If you specify the
accessVirtualDisk parameter, the only
property that you can set is the
logicalUnitNumber.
logicalUnitNumber
Defines specific virtual disk-to-LUN mappings to
an individual host or assigns the host to a host
group.
host
Specifies the name of the host to which the virtual
disk is mapped. You must put quotation marks (" ")
around the host name.
340