CLI Guide

Parameter Description
cacheFlushModifier
The maximum amount of time that data for the
virtual disk stays in cache before the data is flushed
to physical storage. Valid values are listed in the
Notes section.
cacheReadPrefetch
The setting to turn on or turn off cache read
prefetch. To turn off cache read prefetch, set this
parameter to FALSE. To turn on cache read
prefetch, set this parameter to TRUE.
cacheWithoutBatteryEnabled
The setting to turn on or turn off caching without
batteries. To turn on caching without batteries, set
this parameter to TRUE. To turn off caching
without batteries, set this parameter to FALSE.
mediaScanEnabled
The setting to turn on or turn off media scan for
the virtual disk. To turn on media scan, set this
parameter to TRUE. To turn off media scan, set this
parameter to FALSE. (If media scan is disabled at
the storage array level, this parameter has no
effect.)
replicationCacheEnabled
The setting to turn on or turn off the replication
cache. To turn on the replication cache, set this
parameter to TRUE. To turn off the replication
cache, set this parameter to FALSE.
modificationPriority
The priority for virtual disk modifications while the
storage array is operational. Valid values are
highest, high, medium, low, or lowest.
preReadConsistencyCheck
The setting to turn on or turn off preread
consistency checking. Turning on preread
consistency checking verifies the consistency of
RAID redundancy data for the stripes containing
the read data. Preread consistency checking is
performed on read operations only. To turn on
preread consistency checking, set this parameter
to TRUE. To turn off preread consistency checking,
set this parameter to FALSE.
NOTE: Do not use this parameter on non
redundant virtual disks, such as RAID 0 virtual
disks.
readCacheEnabled
The setting to turn on or turn off the read cache.
To turn on the read cache, set this parameter to
TRUE. To turn off the read cache, set this
parameter to FALSE.
consistencyCheckEnabled
The setting to turn on or turn off the write cache.
To turn on the write cache, set this parameter to
343