CLI Guide

Parameter Description
sysLocation
The physical location of the system, such as "3rd
flr". Enclose the SNMP system location in square
brackets([ ]).
Update SNMP Trap Destination
Description
This command turns on or turns off sending authentication failure messages for an SNMP trap
destination. Failure occurs when the SNMP agent received a message from an SNMP manager, but the
message contained an invalid community name.
Syntax
set snmpTrapDestination trapReceiverIP=ipAddress
communityName="communityName"
[sendAuthenticationFailureTraps=(TRUE | FALSE)]
Parameters
Parameter Description
trapReceiverIP
The IP address of the SNMP manager to which you
want to send trap messages.
communityName
The name of the SNMP community for which you
want to send trap messages.
sendAuthenticationFailureTraps
This parameter turns on or turns off sending
authentication failure messages to an SNMP
manager. To send authentication failure messages,
set the parameter to TRUE. To prevent sending
authentication failure messages, set the parameter
to FALSE. The default is TRUE.
Validate Storage Array Security Key
Description
This command validates the security key for a storage array that has self-encrypting disk physical disks to
make sure that the security key is not corrupt.
Syntax
validate storageArray securityKey
file="fileName"
passPhrase="passPhraseString"
422