CLI Guide

Blink SSD Cache
Description
The start locate command identifies the Solid State Disks (SSDs) that are being used in the SSD cache
by turning on the indicator lights for the SSDs. The stop locate command turns off the indicator lights
on the SSDs.
Syntax Applicable To Starting A Blink Operation
start ssdCache [ssdCacheName] locate
Syntax Applicable To Stopping A Blink Operation
stop ssdCache locate
Parameter
Parameter Description
ssdCache
The alphanumeric identifier (including - and _) of
the SSD cache that you want to locate. Enclose the
identifier in square brackets ([ ]). If the SSD cache
name contains special characters or consists only
of numbers, you also must enclose the identifier in
double quotation marks (" ") inside square brackets.
Cancel Remote Replication Group Role Reversal
Description
This command cancels a pending role reversal operation between remote replication groups.
Syntax
stop asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"] rolechange
Parameter
Parameter Description
asyncRemoteReplicationGroup
The name of the remote replication group for
which you want to cancel the pending role reversal
operation. Enclose the remote replication group
name in square brackets ([ ]). If the remote
replication group name has special characters, you
also must enclose the remote replication group
name in double quotation marks (" ").
146