CLI Guide

Clear Storage Array Configuration
Description
Use this command to:
• Clear the entire storage array configuration, and return it back to the initial installation state.
• Clear the configuration except for security information and identification information.
• Clear disk group configuration information and virtual disk configuration information only.
CAUTION: As soon as you run this command, the existing storage array is deleted.
Syntax
clear storageArray configuration (all | diskGroups)
Parameters
If you do not enter a parameter, this command removes all configuration information for the storage
array, except for the information related to security and identification.
Parameter Description
all
The setting to remove the entire configuration of
the storage array, including security and identity
information. Removing all configuration
information returns the storage array to its initial
state.
diskGroups
The setting to remove the virtual disk configuration
and the disk group configuration. The rest of the
configuration stays intact.
NOTE: When you run this command, the storage array becomes unresponsive, and all script
processing is cancelled. You must remove and re-add the storage array to resume communication
with the host. To remove an unresponsive storage array, access the Enterprise Management
Window, and click Edit → Remove. To re-add the storage array, access the Enterprise Management
Window, click
Edit → Add Storage Array, and enter the appropriate IP addresses.
Set Storage Array Controller Health Image
Description
This command sets a flag on a RAID controller module to allow a new controller health image to
overwrite an existing controller health image.
Syntax
set storageArray coreDumpAllowOverWrite
154