CLI Guide

NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Clear Virtual Disk Unreadable Sectors
Description
This command clears the unreadable sector information from one or more virtual disks.
Syntax
clear (allVirtualDisks | virtualDisk
[virtualDiskName] | virtualDisks [virtualDiskName1
... virtualDiskNameN]) unreadableSectors
Parameters
Parameter Description
allVirtualDisks
Clears unreadable sector information from all of the virtual disks
in the storage array.
virtualDisk or virtualDisks The name of the specific virtual disk for which you want to clear
unreadable sector information. You can enter more than one
virtual disk name. Enclose the virtual disk name in square
brackets ([ ]). If the virtual disk name has special characters, you
also must enclose the virtual disk name in double quotation
marks (“ ”).
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Configure Automatic Support Bundle Collection
Description
This command enables or disables the automatic collection of support bundles on one or more storage
arrays when a critical Major Event Log (MEL) event is detected.
NOTE: This command must be run from the command line. It cannot be run in the MD Storage
Manager script editor.
Syntax
supportBundle auto (enable|disable) (all | storageArrayName)
[data=directorypath]
157