CLI Guide

Parameter Description
• enabled—The virtual disk candidates have
security enabled.
The default value is none.
securephysicalDisks
The type of secure drives to use in the virtual disk
group. These settings are valid:
• fips — To use FIPS compliant drives only.
• sed — To use SED compliant drives only.
NOTE: At this time, the controller firmware
does not support mixed FIPS and SED
drives within disk groups or disk pools.
CAUTION: Use this parameter along with
the securityType parameter. If you
specify none for the securityType
parameter, the value of the
securePhysicalDisks parameter is
ignored, because non-secure disk pools
do not need to have secure drive types
specified.
physicalDiskMediaType
You must use this parameter when you have more
than one type of physical disk media in your
storage array.
Valid physical disk media are:
• hdd—Use this option when you have hard disk
drives.
• ssd—Use this option when you have solid state
disks.
• unknown—Use this option if you are not sure
what types of physical disk media are in the
expansion enclosure.
• allMedia—Use this option when you want to
use all types of physical disk media that are in
the expansion enclosure.
The default value is hdd.
dataAssurance
The setting to specify that a disk pool has data
assurance protection to make sure that the data
maintains its integrity. When you use this
parameter, only protected physical disks can be
used for the disk pool.
These settings are valid:
• none – The disk pool does not have data
assurance protection.
• enabled – The disk pool has data assurance
protection. The disk pool supports protected
information and is formatted with protection
information enabled.
The default value is none.
171