CLI Guide

Parameter Description
securityType
The setting to specify the security level when
creating the disk groups and all associated virtual
disks.
• none—The disk group and virtual disks are not
secure.
• capable—The disk group and virtual disks are
capable of having security set, but security has
not been enabled.
• enabled—The disk group and virtual disks have
security enabled.
For information about securityType, see
Security Type.
The type of secure drives to use in the disk group.
These settings are valid:
• fips — To use FIPS compliant drives only.
• sed — To use SED compliant drives only.
NOTE: At this time, the controller firmware
does not support mixed FIPS and SED drives
within disk groups and disk pools.
CAUTION: Use this parameter along with the
securityType parameter. If you specify
none for the
securityType parameter, the
value of the securePhysicalDisks
parameter is ignored because non-secure
disk groups do not need to have secure drive
types specified.
dataAssurance
The setting to specify that a disk pool has data
assurance protection to make sure that the data
maintains its integrity. When you use this
parameter, only protected physical disks can be
used for the disk pool.
These settings are valid:
• none – The disk pool does not have data
assurance protection.
• enabled – The disk pool has data assurance
protection. The disk pool supports protected
information and is formatted with protection
information enabled.
The default value is none.
NOTE: This option is only valid for
enablement, if the drives support DA.
drawerLossProtect
The setting to enforce drawer loss protection
when you create the replicated repository virtual
disk. To enforce drawer loss protection, set this
parameter to TRUE. The default value is FALSE.
183