CLI Guide

Parameter Description
The default option is none.
warningThreshold
Valid values are from 1 to 100.
The default value is determined by the RAID
controller module firmware.
Setting this parameter to 100 disables warning
alerts.
repositoryExpansionPolicy
Valid values are automatic and manual.
cacheReadPrefetch
The setting to turn on or turn off cache read
prefetch. To turn off cache read prefetch, set this
parameter to FALSE. To turn on cache read
prefetch, set this parameter to TRUE.
securityType
The setting to specify the security level when
creating the disk groups and all associated virtual
disks.
• none—The disk group and virtual disks are not
secure.
• capable—The disk group and virtual disks are
capable of having security set, but security has
not been enabled.
• enabled—The disk group and virtual disks have
security enabled.
NOTE: This option is only valid for
enablement, if the drives support DA.
Use the securityType parameter to specify the
security settings for the disk group and associated
virtual disks.
Before you can set the securityType parameter
to capable or enabled, you must create a
storage array security key. Use the create
storageArray securityKey command to
create a storage array security key. These
commands are related to the security key:
• create storageArray securityKey
• enable virtualDiskGroup
[diskGroupName] security
• export storageArray securityKey
• import storageArray securityKey
• set storageArray securityKey
• start secureErase (drive | drives)
• set PhysicalDisk securityID
securePhysicalDisks
Secure-capable drives can be either Self-
Encrypting Disk (SED) drives or Federal Information
Processing Standard (FIPS) drives. Use the
securePhysicalDisks parameter to specify the
185