CLI Guide

Parameter Description
fails, you can bypass the failure by using this
parameter when running the command.
Before any download, the RAID controller module
checks the event log to determine if an event has
occurred that might prevent the new NVSRAM
from successfully downloading. If such an event
has occurred, the RAID controller module normally
does not download new NVSRAM.
This parameter forces the RAID controller module
to download new NVSRAM. The default value is
FALSE. Set this value to TRUE if you want to force
the RAID controller module to download new
NVSRAM.
Enable Disk Group Security
Description
This command converts a non-secure disk group to a secure disk group.
Syntax
enable diskGroup [diskGroupName] security
Parameter
Parameter Description
diskGroup
The alphanumeric identifier (including - and _) of
the disk group that you want to place in the
Security Enabled state. Enclose the disk group
identifier in square brackets ([ ]).
Additional Information
To successfully run this command, the following conditions must be met:
• All physical disks in the disk group must be self-encrypting disk (SED) physical disks.
• The Physical Disk Security premium feature must be enabled.
• The storage array security key must be set.
• The disk group must be Optimal, and not have snapshot virtual disks or repository virtual disks.
The RAID controller module firmware creates a lock that restricts access to the SED physical disks. SED
physical disks have a state called Security Capable. When you create a security key, the state is set to
Security Enabled, which restricts access to all SED physical disks that exist within the storage array.
231