CLI Guide

Enable Disk Pool Security
Description
This command converts a non-secure disk pool to a secure disk pool.
Syntax
enable diskPool [diskPoolName] security
Parameter
Parameter Description
diskPool
The alphanumeric identifier (including - and _) of
the disk pool that you want to place in the Security
Enabled state. Enclose the disk pool identifier in
square brackets ([ ]).
Notes
All of the physical disks that comprise the disk pool must be security capable.
Enable or Disable ODX
This command turns on or turns off Offloaded Data Transfer (ODX) for a storage array. The storage array
comes with ODX turned on. Use this command to turn off ODX if you do not want to run ODX, or if ODX
is causing issues with the storage array. The only storage array that is affected is the storage array on
which the command is run.
Syntax
set storageArray odxEnabled=(TRUE | FALSE)
Parameter
Parameter Description
odxEnabled
The setting to turn on or turn off ODX. To turn on
ODX set this parameter to TRUE. To turn off ODX
set this parameter to FALSE. The default setting is
that ODX is turned on.
232