CLI Guide

Syntax
enable storageArray (featurePack | feature) file=”filename”
Parameter
Parameter Description
file
File path and file name of a valid feature key file.
Valid file names for feature key files must end with
a .key extension. You must put quotation marks ("
") around the file path and file name.
Additional Information
A feature pack is a predefined set of premium features, such as Storage Partitioning and Remote
Replication. These premium features are combined for the convenience of the users.
A premium feature is an additional application to enhance the capabilities of a storage array.
NOTE: Before you enable the High Performance Tier premium feature, stop all host I/O operations
to the storage array. When you enable the High Performance Tier premium feature, both RAID
controller modules in the storage array immediately reboot.
Establish Remote Replicated Pair
Description
Use this command to complete a remote replicated pair on the remote storage array by adding a
secondary virtual disk to an existing remote replication group. Before you run this command, the remote
replication group must exist and the primary virtual disk must exist in the remote replication group. After
this command successfully completes, remote replication starts between the primary virtual disk and the
secondary virtual disk.
The two virtual disks comprising a remote replicated pair function as a single entity. Establishing a remote
replicated pair allows you to perform actions on the entire replicated pair versus the two individual virtual
disks.
Syntax
establish asyncRemoteReplication virtualDisk="secondaryVirtualDiskName"
asyncRemoteReplicationGroup="asyncRemoteReplicationGroupName"
primaryVirtualDisk="primayVirtualDiskName"
Parameters
Parameter Description
asyncRemoteReplication
The name of an existing virtual disk on the remote
storage array that you want to use for the
235