CLI Guide

Parameter
Parameter Description
addPhysicalDisks
The setting to add new physical disks to the virtual
disk. For dense expansion enclosures, specify the
enclosure ID value, the drawer ID value, and the
slot ID value for the physical disk. For non-dense
expansion enclosures, specify the enclosure ID
value and the slot ID value for the physical disk.
Enclosure ID values are 0 to 99. Drawer ID values
are 0 to 4. Slot ID values are 0 to 31. Enclose the
enclosure ID value, drawer ID value, and the slot ID
value in parentheses. Use this parameter with the
addCapacity parameter if you need to specify
additional physical disks to accommodate the new
size.
Each disk pool must be created from a minimum
of 11 physical disks specified. There is no upward
limit of physical disks supported in a single disk
pool, but the number cannot exceed the number
of physical disks supported on the storage array.
Load Storage Array DBM Database
Description
This command uploads a Database Management (DBM) database image from a file or from cache. This
command restores a storage array DBM database to the exact configuration that existed when the
database image was captured using the save storageArray dbmDatabase command. The data in a
file can be just RAID configuration data or all data, including data for RAID configuration, disk groups and
disk pools. The data in a cache location always includes all data.
Before using this command with the file option, you must first obtain a validator string (a security code)
from your Technical Support representative. To obtain a validator, use the save storageArray
dbmValidator command to generate an XML file that contains validator information.
Syntax
load storageArray dbmDatabase
((file="filename" validator="validatorValue") | sourceLocation=onboard)
[controller [(0|1)]]
[contentType=(raidConfigration | all)]
Parameters
Parameter Description
file
The file path and the file name of the DBM
database you want to upload. Enclose the file
name in double quotation marks (" "). For example:
237