CLI Guide

Parameter Description
the name is longer than 30 characters, the angle
brackets must be used.
targetName
The name of the iSCSI target for which session
information is desired. Enclose the iSCSI target
name in double quotation marks (“ ”). The name
and quotation marks must also be enclosed in
either square brackets ([ ]) or angle brackets (< >). If
the name is longer than 30 characters, the angle
brackets must be used.
NOTE: This command can be entered without defining any arguments, i.e. show iscsiSessions.
When the command is entered without arguments, the information displayed is for all active iSCSI
sessions. To limit the information displayed, enter a specific iSCSI initiator or a specific iSCSI target.
The command then displays only information about that particular iSCSI initiator or iSCSI target
session.
Show Disk Group
Description
This command returns the following information about a disk group:
• Status (online or offline)
• Physical disk type (SAS)
• Enclosure loss protection (yes or no)
• Current owner (RAID controller module 0 or RAID controller module 1)
• Associated virtual disks and free capacity
• Associated physical disks
NOTE: You can use the free capacity area value when you create a virtual disk based on the free
capacity of a disk group. For a description of how to use the free capacity value, see the create
virtualDisk
command on Create RAID Virtual Disk (Free Capacity Base Select).
Syntax
show diskGroup [diskGroupNumber]
Parameter
Parameter Description
diskGroup
Number of the disk group for which to display
information. You must put brackets ([ ]) around the
disk group number.
349