CLI Guide

Parameter Description
port values are 1 or 2. You must put brackets ([ ])
around the physical disk channel values.
physicalDiskChannels
Identifier number of the physical disk ports for
which to display information. Valid physical disk
port values are 1 or 2. You must put brackets ([ ])
around the physical disk channel values.
allPhysicalDiskChannels
The identifier that selects all of the physical disk
ports.
Show Physical Disk Download Progress
Description
This command returns the status of firmware downloads for the physical disks targeted by the download
physicalDisk firmware or download storageArray physicalDiskFirmware commands.
Syntax
show allPhysicalDisks downloadProgress
Parameters
None.
NOTE: When all firmware downloads have successfully completed, this command returns a
Successful status. If any firmware downloads fail, this command shows the firmware download
status of each targeted physical disk. This command returns the status values shown in the
following table.
Status Definition
Successful Downloads completed without errors.
Not Attempted Downloads did not start.
Partial Download Downloads are in progress.
Failed Downloads completed with errors.
Show RAID Controller Module
Description
For each RAID controller module in a storage array, this command returns the following information:
• Status (Online, Offline)
• Current firmware and NVSRAM configuration
• Pending firmware and NVSRAM configuration configurations (if any)
• Board ID
354