CLI Guide

Parameter Description
replication group name has special characters, you
also must enclose the remote replication group
name in double quotation marks (" ") inside square
brackets. If the remote replication group name
consists only of numbers, such as "1002," you also
must enclose the remote replication group name
in double quotation marks (" ") inside square
brackets.
synchronizationProgress
Use this optional parameter to display the periodic
synchronization progress of the remote replication
group.
Show Remote Replication Virtual Disk Candidates
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command returns information about the candidate virtual disks on a remote storage array that can
be used as secondary virtual disks in a Remote Replication configuration.
Syntax
show remoteReplication candidates primary= ”virtualDiskName”
remoteStorageArrayName=storageArrayName
Parameters
Parameter Description
primary
The name of the local virtual disk that you want for
the primary virtual disk in the remote-replicated
pair. Enclose the primary virtual disk name in
double quotation marks (“ ”).
remoteStorageArrayName
The remote storage array that contains possible
virtual disks for a secondary virtual disk. If the
remote storage array name has special characters,
it must be enclosed in double quotation marks (“ ”).
Show Remote Replication Virtual Disk Synchronization
Progress
NOTE: This command valid only with Fibre Channel storage arrays.
358