CLI Guide

Parameter Description
secure drives to use. The values you can use are
fips and sed.
NOTE: The controller firmware does not
support a mix of SED and FIPS drives within
disk groups or disk pools.
Example command
autoConfigure storageArray
securityType=capable
securePhysicalDisks=fips;
dataAssurance
The setting to specify that a disk group, and the
virtual disks within the disk group, has data
assurance protection to make sure that the data
maintains its integrity. When you use this
parameter, only protected physical disks can be
used for the disk group. These settings are valid:
• none - No explicit data assurance is defined.
The disk group will be comprised of virtual disks
that may or may not have data assurance,
depending on the availability of data assurance
enabled physical disks. Data Assurance is
enabled on virtual disks created on disk groups
that support data assurance. If only data
assurance physical disks are available, the disk
groups will be data assurance enabled.
• enabled - The disk group has data assurance
protection. The disk group supports protected
information and is formatted with protection
information enabled.
NOTE: This option is only valid for
enablement, if the drives support DA.
Autoconfigure Storage Array Hot Spares
Description
This command automatically defines and configures the hot spares in a storage array. You can run this
command at any time. This command provides the best hot spare coverage for a storage array.
Syntax
autoConfigure storageArray hotSpares
Parameters
None.
NOTE: When you run the autoconfigure storageArray hotSpares command, the RAID
controller module firmware determines the number of hot spares to create based on the total
number and type of physical disks in the storage array.
145