Support Matrix
Table Of Contents
- Dell EMC PowerVault MD34XX/38XX Series Support Matrix
- Introduction
- Data protocols
- Dell EMC PowerVault MD Series storage array rules
- Default IPv4 settings for management ports on Dell EMC PowerVault MD series storage arrays
- RAID controller firmware and NVSRAM
- iSCSI software initiators
- Protocol (TOE/iSCSI) offload adapters
- Fibre Channel SFP+ Transceiver support
- Physical disks
- Expansion enclosures
- Management software
- Operating systems
- Windows ODX
- ALUA support on host operating systems
- Device mapper software
- SAS host bus adapters
- Fibre Channel host bus adapters
- Fibre Channel direct-attach configuration operating systems
- Required timeout settings for Fibre Channel host bus adapters
- Supported Fibre Channel switches
Default IPv4 settings for management ports
on Dell EMC PowerVault MD series storage
arrays
NOTE: No default gateway is set.
By default, the management ports on the storage array are set to DHCP. If DHCP fails, the following IPv4 settings are used:
Table 5. Default IPv4 management port addresses
MD3400/MD3420/MD3800x/MD3820x
Controller/port IPv4 address Subnet mask
Controller 0, Port 1 192.168.129.101 255.255.255.0
Controller 1, Port 1 192.168.129.102 255.255.255.0
MD3460/MD3860x
Controller/port IPv4 address Subnet mask
Controller 0, Port 0 192.168.128.101 255.255.255.0
Controller 1, Port 0 192.168.128.102 255.255.255.0
Default IPv4 settings for the iSCSI ports on
PowerVault MD38x0i Storage Arrays
NOTE:
No default gateway is set.
Controller/port IPv4 address Subnet mask Port #
Controller 0, Port 0 192.168.130.101 255.255.255.0 3260
Controller 0, Port 1 192.168.131.101 255.255.255.0 3260
Controller 1, Port 0 192.168.130.102 255.255.255.0 3260
Controller 1, Port 1 192.168.131.102 255.255.255.0 3260
4
10 Default IPv4 settings for management ports on Dell EMC PowerVault MD series storage arrays