Users Guide

Abbildung 3. Replikation mehrerer virtueller Laufwerke

Setting Up Remote Replication On The MD Storage Array

NOTE: You must activate the Remote Replication premium feature before performing the steps below. For step-by-

step instructions on using MD Storage Manager (MDSM) to set up Remote Replication, see the Administrator's

Guide for your array at dell.com/support/manuals.

Before installing and configuring SRM, you must set up Remote Replication on each MD storage array used in the

recovery solution.

NOTE: Setup of Remote Replication on iSCSI based PowerVault storage MD Series array is governed by iSCSI

array documents available on dell.com/support/manuals.

To set up Remote Replication on the storage array:

1. Start MD Storage Manager (MDSM) on your management host.

2. Open the Enterprise Management Window (EMW) and discover both the protected and recovery site's storage

array.

3. Open the Array Management Window (AMW) for the protected site's storage array and identify a virtual disk to be

used in the recovery solution.

4. Open the AMW for the recovery site's storage array and create a similar-sized, remotely replicated virtual disk.

5. Right-click on the protected site's storage array virtual disk and select Create Remote Replication

6. Select the settings appropriate for your environment and allow remote replication to synchronize.

7. Repeat these steps for:

a. Each virtual disk to be remotely replicated

b. Each storage array in the recovery solution

Host-zu-Speicher-Array-Konfiguration

Um eine optimale Leistung und ein ordnungsgemäßes Multi-Pathing für die Konfiguration zu gewährleisten, müssen das

Switch-Fabric und die iSCSI-Verbindung, die die geschützten und Wiederherstellungs-Host-Standorte mit den Speicher-

Arrays verbinden, korrekt konfiguriert sein. Das folgende Diagramm zeigt eine Basiskonfiguration, die eine vollständige

Redundanz bietet: