Owners Manual

Removing a 3.5 Inch Physical-Drive Blank
CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks installed.
1. If installed, remove the front bezel.
2. Press the release button and slide the physical-drive blank out until it is free from the physical-drive slot.
Figure 10. Removing and Installing a 3.5 Inch Hard-Drive Blank (MD3800i only)
1. physical-drive blank
2. release button
Installing a 3.5 Inch Physical-Drive Blank
1. If installed, remove the front bezel.
2. Insert the physical-drive blank into the physical-drive slot until the release button clicks into place.
3. If applicable, install the front bezel.
Removing a Hot-Swap Physical Drive
CAUTION:
To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the
documentation supplied with your operating system.
1. From the management software, prepare the physical drive for removal. Wait until the indicators on the physical-drive carrier
signal that the physical drive can be removed safely. For more information, see the documentation for the storage controller.
If the physical drive is online, the green activity/fault indicator flashes as the drive is turned off. When the physical-drive
indicators are off, the physical drive is ready for removal.
2. Press the release button to open the physical-drive carrier release handle.
3. Slide the physical-drive carrier out until it is free of the physical-drive slot.
CAUTION:
To maintain proper system cooling, all empty physical-drive slots must have physical-drive blanks
installed.
4. Insert a physical-drive blank in the empty physical-drive slot.
Installing Array Components
17